Panasonic SC-HT280 Manuel D'utilisation page 38

Reference tor speakers
Center speaker
Surround
speaker
(left)
(left) (right)
1 2
Surround
speaker
(right)
Subwoofer
3
1
2
3
POWER
6/I
A SPEAKERS B
A SPEAKERS 8
A
The speaker indicators
This part of the display indicates which speakers sound comes
from.
The corresponding indicators will not light if you selected "NONE"
during the speaker setting procedure (see below), or If you turned
the subwoofer off (■► page 22).
The surround and center speaker indicators do not light when
STEREO mode is selected (■► page 20).
B
speaker settings
The following settings may be necessary if you replace the
speakers included with this unit. They should be performed in this
case to get the most from this unit's reproduction modes (^ pages
10-19).
Front, center, and surround channel settings
Set the SIZE, DISTANCE, and FILTER for your speakers.
In SIZE
Set the type (LARGE or SMALL) and presence of your speakers.
Select "LARGE" if the speakers can produce bass (below around
100 Hz). Select "SMALL" if the speakers cannot produce bass. If
you aren't using center or surround speakers select "NONE" so
the sound is produced through the front speakers.
The speaker channels are all set to "SMALL" before shipping. If all
your speakers are SMALL, you may skip this operation.
In DISTANCE
Enter the distance of each speaker from the listening position so
the sound from the speakers reaches the listening position at the
same time. The unit calculates the delay time for the center and
surround speakers based on these distances.
In FILTER
Enter the cutoff frequency for your subwoofer based on the bass
capability of your front speakers
The factory setting is 150 Hz.
1 Press [POWER, 6/1]-
2 Press [A] and [B] at the same time.
"SETTING" appears on the display.
3 Press [A] to select what you want to
set.
Each time the button is pressed the display switches as
follows.
SIZE —- DISTANCE —- FILTER —- DR COMP
t_I
(continued on next page)
38
RQT5307