Publicité
Les langues disponibles
Les langues disponibles
Digital Signal Processor (DSP)
DSP SFCMODE
-DSP ON/DEFEAT
DIGITAL INPUT
»TtREO SURROUND SFC
/ /
i_t
/ /_ /_/
i t it
i i t i
i \
/_
/ l\/t
III!
_n n \! \
SFC modes
The SFC (Sound Field Control) function gives presence and
spread thereby enhancing and enriching the music or movie.
Read the following explanations better understand how to make
your selection.
IJHgj
SFC is designed to add surround*llke effects to stereo sources.
Select the appropriate mode when playing back Dolby Digital,
DTS, or Dolby Surround sources.
HALL
This mode imparts a reflection and spread which will make you
feel as if you are in a large concert hall.
CLUB
Like a jazz club, this mode provides an exciting and intimate
atmosphere. It simulates the sound field of a relatively small room
having a low ceiling and hard reflective surfaces, for a "live" sound
with enhanced presence to bring the performers up close.
LIVE
Primarily for vocal pieces, this mode adds gloss to the vocals and
you'll feel as though you were hearing a live stage performance.
THEATER
You can clearly perceive the directions and source of the movie.
Real ambience of sound can also be recreated naturally using this
mode.
SIM SURR (SIMULATED)
Choose this mode if little or no sound will be heard from the
surround speakers.
You can feel as if you were in a more expanded space adding to
the actual sound from the source.
This mode also adds effect to monaural sources by outputting
sound from surround speakers.
If the beginning of a track is cut off when playing CDs
The beginning of a track may not be heard if you play CDs in
STEREO mode.
You can solve this by engaging the PCM FIX mode.
Press and hold [DIGITAL INPUT] for tour seconds.
"PCM FIX" appears on the display.
This mode can be selected for each source, but is cancelled when
the unit is turned off.
• The PCM FIX mode can be selected in STEREO mode only.
• Dolby Digital and DTS sources cannot be played while PCM
FIX mode is on.
• Noise can occur -if DTS sources are played while PCM FIX
mode is engaged. To avoid this, be sure to turn PCM FIX mode
off after use.
If reception is weak or *TUNED'' fails to light
completely while playing the radio
Press and hold [-DSP ON/DEFEAT] until "DEFEAT" appears on
the display.
Press and hold again to turn DSP on. The STEREO mode is
selected.
This allows you to play back sound without it passing through the
digital signal processor ,(DSP). When this is selected, no sound
will go through the center or surround speakers or the subwoofer.
When "DEFEAT' is selected the sound mode indicators (STEREO,
SURROUND and SFC) go out and these modes can not be
selected.
19
RQT5307
Publicité
