Publicité
Fitting the Hose Guide
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched
off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation.
NOTE: DO NOT push the vacuum hose
onto the floor tool with the floor tool in the
raised position.
Filling the Clean Water Tank
A
To fill the clean-water tank, use the FLEXI - FILL pipe from either a tap
or hose pipe. (Fig.C).
The large cap can also be used for filling from a bucket, hose or suitable container.
(Fig.A & B).
Fill the clean-water tank to MAX line indication on tank, including cleaning chemicals if
required. Follow chemical manufacturing guide lines.
The clear dump hose at the rear of the machine can be used to see the level of the
clean-water. (Fig.D).
NOTE: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.)
are not allowed to enter the clean water tank during the filling process. If using a bucket
or similar, ensure it is always clean and free from debris.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specification.
For further guidance on hazardous substances refer to health and safety instructions online.
B
11
Machine Set-up Guide
Refit vacuum hose to the
Floor tool when finished.
C
D
Publicité
