Signature STV4F Manuel D'utilisation page 47

IMPORTANT: You must observe the ventilation requirements shown in the
drawing opposite.
There are ventilation holes around the outside of the hob. YOU
MUST ensure that these holes are not blocked by the work top, when you put
the hob into position (see drawing opposite).
IMPORTANT: Do not use a silicon sealant to seal the appliance against the
aperture. This will make it difficult to remove the hob from the aperture in future,
particularly if it needs to be serviced
Carefully turn the hob back over and then gently lower it into the aperture

hole that you have cut out.
There are holes on the base or the sides of the hob that you can fix the

four brackets to.
You should place the bracket on the underneath of the hob, in a position

that is appropriate for the aperture that you have cut out. Using the screws
provided, fix the bracket to the hob. These screws MUST be securely tightened.
EN-12