Signature STV4F Manuel D'utilisation page 45

INSTALLATION
Installing the ceramic hob
The kitchen area should be dry and aired and equipped with efficient

ventilation. When installing the ceramic, easy access to all control
elements should be ensured.
This is a Y-type design built-in ceramic, which means that its back wall

and one side wall can be placed next to a high piece of furniture or a
wall .Coating or veneer used on fitted furniture must be applied with a
heat-resistant adhesive (100℃).This prevents surface deformation or
detachment the coating.
Range should be installed according to the manufacturer's instructions.

Assembly of ceramic hob :
Put a towel or cloth on the work surface.Place the hob face down on the

protected surface.
Apply the strip seal, supplied with the hob, which is for sealing it onto the

work surface.
Do not use silicone. Apply the seal to the edge of the bottom of the hob,
leaving about 3mm from the edge of the glass. Apply the seal all around the
circumference.
Cut any excess and bring the two ends of the seal together so they match.
EN-10