Publicité
Les langues disponibles
Les langues disponibles
LOCK OUT PROGRAMMING
The instrument is delivered with the programming locked out, giving access to all the programming levels. Once com-
pleted the instrument programming we recommend the following security measures be taken:
•
Lock out the programming access to prevent from programmed parameters modifications.
•
Lock out keyboard functions to prevent from accidental modifications.
•
There are two lockout modes: selective and total. If the parameters are going to be readjusted frequently, make
a selective lockout. If no adjustment is going to be made, make a total lockout. Keyboard functions lockout is
always possible.
•
The access to the lockout routine is allowed by entering a personalised code. We recommend changing the code
set at factory and to write down your personalised code and keep it in a safe place.
TOTAL LOCKOUT
The access to the programming routines to read data is allowed even if all parameters are locked out totLC=1, but it
won't be possible to enter or modify data. In this case, when entering in the programming mode, the display
shows the indication "-dAtA-".
PARTIAL LOCKOUT
When only some parameters are locked out, all configuration data can be read but only non protected parameters
can be modified. In such case, when entering in the programming mode, the display shows the indication "-Pro-".
Menus or submenus that can be locked out are:
•
Setpoint 1 configuration (SEt 1).
•
Setpoint 2 configuration (SEt 2).
•
Setpoint 3 configuration (SEt 3).
•
Setpoint 4 configuration (SEt 4).
•
Input configuration (InPut).
•
Display (diSP).
•
Display color (CoLor).
•
Setpoints value (SPVAL)
•
Serial output (rSout) or Ethernet ouput (EtnEt) configuration
•
Analog output configuration (Anout).
•
Logic inputs configuration (LoGIn).
•
Programming of the key TARE (tArE).
•
Direct access to MAX. and MIN values (MAHMn).
The first four and "SEtVAL" only appear if the corresponding option 2RE, 4RE, 4OP ó 4OPP has been installed, "diSP",
"FiltP" and "tARE" do not appear when the instruments configured for temperature measurement. "Anout" will appear
when any of the NMA or NMV options are installed, "rSout" when any of the RS2 or RS4 and "EtnEt" for ETH output op-
tions are installed.
SECURITY MENU DIAGRAM
The following figure shows the security menu. In this menu is configured the programming lockout. The access to this
menu is accomplished from the run mode by pressing the
pears.
The instrument is shipped from factory with the following default code: "0000". Once entered this code, the "LISt" indi-
cation will appear, from which we will enter in the parameters lockout. Acceding to the "CHAnG" menu will allow us to
enter a personal code, that we have to write down and keep in a safe place (Do not count on your memory). This
personal code makes the default code useless.
If an incorrect code is entered, the instrument will return automatically to the run mode.
Total lockout programming is achieved changing to 1 the "totLC" variable, changing it to 0, will lead to the selective
lockout of the programming variables. Programming each one of the parameters to 1 will active the lockout, if they are
set to 0 programming will be accessible. Though the programming is locked out, it remains possible to visualise the cur-
rent programming.
The "StorE" indication informs that the modifications effectuated have been stored correctly.
KOSMOS SERIE
key during 3 seconds, until the "CodE" indication ap-
www.ditel.es
MICRA-M
85
Publicité
