Publicité
Les langues disponibles
Les langues disponibles
SCALE PROGRAMMING
There are two methods for programming the scale, the SCAL method and the tEACH method. In the following
diagram the SCAL menu has been developed an an example, it is exactly the same menu than the tEACH menu.
dec. point
SCAL method
The input and display values are programmed manually. This method can be used when the value of the signal supplied by the
transducer at each points of the process is known.
tEACH method
The input values are introduced directly from the signal present in the input connector when each point is programmed. The
display values are programmed manually.
This method can be used when it is possible to bring the process to the conditions of each one of the points to be programmed.
Programming of the linearization points
You can accede to the first two points input-display by pressing on the
the points, press on
by pressing on
key. When enough points has been programmed to define the process, press on
programming of the last DSP n value, to get out of the scale programming routine. The rest of the points, up to 11, that have
not been programmed are omitted from the display calculation.
Input points
-19999
99999
to
Display points
-19999
99999
to
Display decimal point
.
.
0 0
0 0
00 0
Accessible from the SCAL or tEACH menu, following the first display point. Once acceded to it , it will start to blink in its present
position and through the
Moreover it will also affect, as well as the display points, the setpoints value and the value of the analog output scale, in case
the corresponding option has been installed.
KOSMOS SERIE
key during approximately 3s from the display value of point 2. From here the progression is achieved
.
.
000 0
0000
key will be able to shift to another position.
www.ditel.es
MICRA-M
key. To accede to the programming of the rest of
during 3s from the
80
Publicité
