SilverCrest SDM 1500 D3 Manuel D'utilisation page 26

˜ Operation
˜ Filling the water tank
m
DANGER! Risk of electric shock! Always
disconnect the power plug
socket before filling the water tank
m
CAUTION! Fill the water tank
or distilled water without any additives. If your
tap water is hard, use distilled water. Where the
water is moderately hard, mix distilled water and
tap water (ratio of 1:1).
NOTES:
Checking the water hardness: Use a test strip or
ask the water supplier.
Do not exceed the water tank's
capacity of 350 ml.
Open the water tank cover
Use the filling cup
water tank .
[ 18 ]
Close the water tank
˜ Turning on/off
Connect the power plug
socket.
Power knob
Turn in clockwise direction Turn the product on.
Turn in counter-clockwise
direction to "0" position.
NOTES:
The product needs around 30 seconds to
preheat. After preheating, the pump starts
operating and with audible sound. The steam
runs continuously until the water tank
When the product is powered on, it should not be
pointed towards equipments containing electrical
components (such as the interior of ovens).
The product has to be unplugged
– after use,
– before cleaning, and
– before maintaining
the product.
from the wall
23 ] [
.
[ 18 ]
with tap water
[ 18 ]
maximum
[ 18 ]
.
[ 18 ]
and the funnel
4 ] [ [ 3 ]
.
[ 18 ]
with a suitable wall
[ 23 ]
On/off
[ 21 ]
The light indicator
turns green.
Turn the product off.
The light indicator
goes off.
18 ] [
˜ Adjusting the steam power
Power knob
Turn in clockwise direction Increase steam power
Turn in counter-clockwise
direction
˜ Pump safety shutdown
When the water tank
keeps operating for about 1 minute. Then, it shuts
down.
The light indicator
green to flashing red colour.
Turn off the product. Refill the water tank
proceed with the operation.
˜ Cleaning and maintenance
to fill the
Cleaning the main unit
m
DANGER! Risk of electric shock!
Disconnect the power plug
socket before cleaning the product.
m
WARNING! Do not immerse the product's
electrical components in water or other liquids.
Never hold the product under running water.
Wipe down the product with a slightly damp
cloth.
Do not let any water or other liquids enter the
[ 19 ]
product interior.
Do not use any abrasive, aggressive cleaners or
hard brushes to clean the product.
[ 19 ]
After cleaning: Let all parts dry completely.
Cleaning the accessories
Clean the accessories in warm, soapy water.
After cleaning: Let all accessories dry completely.
Cleaning the fiber cloths and fiber cover
The fiber cloths
is empty.
cleaned in a washing machine and in a dry cleaner.
Clean the fiber cloths
with a mild setting, up to 60 °C.
After cleaning: Let all parts dry completely.
Steam power
[ 21 ]
Decrease steam power
is empty, the pump
18 ] [
changes from continuous
19 ] [
from the wall
23 ] [
and the fiber cover
14 ] [
and the fiber cover
[ 14 ]
to
18 ] [
can be
8 ] [
8 ] [
GB/IE 23