Publicité
Les langues disponibles
Les langues disponibles
Inserting/removing the battery
pack
Inserting the battery pack
♦
Set the rotation direction switch 3 to the middle
position (lock). Snap the battery pack 8 into
the handle.
Removing the battery pack
♦
Press the release button 9 and remove the
battery pack 8.
Checking the battery charge level
Press the battery charge level button 6 to
♦
check the charge level of the battery.
The status/remaining charge is shown on the
battery display LED 7 as follows:
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
Changing tools
Your cordless screwdriver has a fully automatic
spindle lock
.
When the motor is at a standstill, the drive train is
locked so that you can open the drill chuck q by
turning it
. After you have attached the desired
tool and locked it in place by turning the chuck
you can continue working. The spindle lock is
released automatically when the motor is started
(by pressing the ON/OFF switch 4).
Torque selection ring/drill setting
You can set the torque using the torque selection
ring w.
♦
Select a low level for small screws or soft
materials.
♦
Select a high level for large screws, hard
materials or removing screws.
♦
For drilling operations, select the drill setting by
moving the torque selection ring w to the
position.
PABS 20-Li H9
2-speed gearbox
CAUTION!
Operate the speed selector switch 1 only
►
when the appliance is at a standstill. Other-
wise, the tool could be damaged.
In first gear
(speed selector switch 1 in position 1),
you can reach a speed of approx. 430 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear
(speed selector switch 1 in position 2),
you can reach a speed of approx. 1500 rpm for
carrying out drilling work.
Use
Switching on/off
Turn on
Press and hold the ON/OFF switch 4 to start
♦
up the appliance.
The LED work light 0 lights up when the ON/
OFF switch 4 is pressed lightly or fully. This
provides illumination of the work area in poor
lighting conditions.
,
Switching off
Release the ON/OFF switch 4 to switch off
♦
the appliance.
Setting the rotational speed
The ON/OFF switch 4 has a variable speed
control. Pressing the ON/OFF switch 4 lightly
yields a low speed. Increasing the pressure
in creases the speed.
NOTE
►
The integrated motor brake ensures that the
tool stops quickly.
GB │ IE
│
7
■
Publicité
