Parkside PABS 20-Li H9 Traduction Des Instructions D'origine page 10

■ Do not exert excessive pressure and only
apply pressure along the length of the drill bit
(no lateral pressure). Drill bits can bend and
break which can lead to a loss of control and
injuries.
Original accessories/attachments
■ Use only the accessories and additional equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance.
WARNING!
■ Do not use any accessories that are not
recommended by PARKSIDE. This can lead to
electric shock and fire.
Safety guidelines for battery
chargers
This tool may be used by children
■
aged 8 years and above and by
persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to
use the tool safely and are aware
of the potential risks. Do not allow
children to use the tool as a toy.
Cleaning and user maintenance
tasks may not be carried out by
children unless they are supervised.
To avoid potential risks, if the appli-
■
ance power cable is damaged, it
must be replaced by the manufac-
turer, its customer service or by a
qualified technician.
The charger is suitable
for indoor use only.
│ GB │ IE
■ 6
WARNING!
■ To avoid potential risks, if the appliance
power cable is damaged, it must be replaced
by the manufacturer, its customer service or
by a qualified technician.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3/
PAPS 204 A1/PAPS 208 A1.
Before use
Charging the battery pack (see fig. A)
CAUTION!
► Always disconnect the mains plug before
removing the battery pack 8 from or
inserting it into the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
Insert the battery pack 8 into the high-speed
♦
charger e (see fig. A).
♦ Insert the mains plug into the mains power
socket. The control LED r lights up red to
indicate that charging is in progress.
The green control LED t indicates that
♦
charging is complete and the battery pack 8 is
ready for use.
Push the battery pack 8 back into the appli-
♦
ance.
PABS 20-Li H9