Publicité
Les langues disponibles
Les langues disponibles
2. Angle grinder: Lock the on/off
switch (6): Tilt the on/off switch (6) up-
wards.
3. Check that the attachment tool is run-
ning smoothly. If not: Replace the at-
tachment tool.
4. Wait until the tool has reached full ro-
tational speed.
5. Guide the attachment tool against the
workpiece.
Switching off
1. Remove the attachment tool from the
workpiece.
2. Angle grinder (on/off switch
locked): Press the back of the on/off
switch (6).
3. Slide the on/off switch (6) to the rear.
4. Wait until the power tool has stopped
before placing it down.
5. Remove the rechargeable battery (34)
from the device if you are leaving the
device unattended or if you have fin-
ished working.
Transport
Information on transporting the device:
• Switch off the device and remove the
rechargeable battery. Make sure that
all moving parts have come to a com-
plete stop.
• Remove the attachment tool.
• Always carry the device by the handle
(7).
Cleaning, maintenance
and storage
WARNING! Risk of injury due to un-
intentional start-up. Protect yourself when
performing maintenance or cleaning work.
Switch off the device and remove the bat-
tery (34).
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
Maintenance
The device is maintenance free.
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• In the case provided (36)
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0°C and 45°C. Avoid extreme
cold or heat during storage to ensure the
battery output is not adversely affected.
Remove the rechargeable battery from the
device before storing the device (see the
separate operating instructions for the bat-
tery and charger).
Storing cutting/grinding discs
• dry
• upright
• unstacked
GB
MT
53
Publicité
