Parkside PMBSA 20-Li A1 Traduction Des Instructions D'origine page 51

3. Assembly: Insert the attachment tool
into the collet chuck (37).
ANGLE GRINDER
Fitting and removing the
attachment on the guard
cover
Activity
Grinding
Abrasive cutting
Fitting the attachment (1) (Fig. B)
1. Disassemble the attachment tool.
2. Place the attachment (1) on the groove
(38) under the guard cover (3) and
turn the attachment (1) until the attach-
ment clicks into place.
Removing the attachment (1)
(Fig. B)
1. Disassemble the attachment tool.
2. Release one of the two locks (39) on
the attachment (1) by pushing the lock
outwards.
3. Slide the released lock (39) over the
guard cover (3) until the attachment is
removed after half a turn.
Attaching and removing
discs
Notes
DANGER! Risk of injury! Only use
•
attachment tools recommended by the
manufacturer.
• Permissible sanding and cutting discs
• diameter: ≤ 50 mm
• Thickness (Cutting disc): ≤ 1,2 mm
• Thickness (Grinding disc): ≤ 4 mm
• Adapter for cutting and grinding discs
with 6.4 mm borehole (40): Use this
adapter instead of the clamping flange
Attachment of
the guard cover
(1)
Attachment removed
Attachment mounted
Disassembly: Pull the attachment
tool out of the collet (37).
4. Tighten the clamping nut (9).
(42) and clamping screw (41) for cer-
tain 38 mm diameter discs.
• Only use undamaged attachment tools.
Tools required
• Hex key (23)
Procedure (Fig. B)
1. Press and hold the spindle lock (5).
2. Loosen the clamping screw (41) with
the hex key (23). You can release the
spindle lock (5).
3. Disassembly: Remove the attach-
ment tool from the mounting flange
(43).
Assembly: Place the attachment tool
on the mounting flange (43).
The running direction of the disc must
match the direction of rotation arrow
(4).
4. Position the clamping flange (42).
5. Press and hold the spindle lock (5).
6. Tighten the clamping screw (41) with
the hex key (23). You can release the
spindle lock (5).
Operation
Working instructions
WARNING! Risk of injury! If pos-
•
sible, use clamps to hold the workpiece
in place. Never hold a small workpiece
in one hand and the device in the other
while using the device.
DANGER! Risk of injury! Ensure
•
that you have sufficient space in which
to work, and that you do not endanger
other people.
GB MT
51