Publicité
Les langues disponibles
Les langues disponibles
GB
MT
• Switch off the device and remove the
rechargeable battery. Make sure that
all moving parts have come to a com-
plete stop:
• to loosen a blocked insertion tool
• in case of unusual sounds
• before checking the device, clean-
ing it or performing maintenance
work on it
• Only use accessories recom-
mended by PARKSIDE. Unsuitable
accessories may cause electric shock
or fire.
Safety Instructions For
Multifunctional Tools
Safety warnings common for
grinding, sanding, wire brushing,
polishing, carving or abrasive
cutting-off operations
• This power tool is intended to
function as a grinder, sander,
wire brush, polisher, carving
or cut-off tool. Read all safety
warnings, instructions, illus-
trations and specifications
provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock, fire
and/or serious injury.
• Do not convert this power tool
to operate in a way which is
not specifically designed and
specified by the tool manufac-
turer. Such a conversion may result in
a loss of control and cause serious per-
sonal injury.
• Do not use accessories which
are not specifically designed
and specified by the tool manu-
facturer. Just because the accessory
can be attached to your power tool, it
does not assure safe operation.
44
• The rated speed of the grind-
ing accessories must be at least
equal to the maximum speed
marked on the power tool. Ac-
cessories running faster than their rated
speed can break and fly apart.
• The outside diameter and the
thickness of your accessory
must be within the capacity rat-
ing of your power tool. Incor-
rectly sized accessories cannot be ad-
equately guarded or controlled.
• The arbour size of wheels,
sanding drums or any other ac-
cessory must properly fit the
spindle or collet of the power
tool. Accessories that do not match
the mounting hardware of the power
tool will run out of balance, vibrate ex-
cessively and may cause loss of con-
trol.
• Mandrel mounted wheels,
sanding drums, cutters or other
accessories must be fully inser-
ted into the collet or chuck. If the
mandrel is insufficiently held and/or
the overhang of the wheel is too long,
the mounted wheel may become loose
and be ejected at high velocity.
• Do not use a damaged access-
ory. Before each use inspect
the accessory such as abrasive
wheels for chips and cracks,
backing pad for cracks, tear
or excess wear, wire brush
for loose or cracked wires.
If power tool or accessory is
dropped, inspect for damage
or install an undamaged ac-
cessory. After inspecting and in-
stalling an accessory, position
yourself and bystanders away
from the plane of the rotating
accessory and run the power
Publicité
