Parkside PMBSA 20-Li A1 Traduction Des Instructions D'origine page 50

GB MT
Attachment
Function tool
Grinding Grinding belt
(28), grit 80
Sandpaper
(30), grit 240
Silicon
carbide moun-
ted point (21)
Cutting Cutting disc
(small) (25)
* Maximum speed [min
Fitting and removing the
attachment tool for the
multi-purpose tool
Notes
• The outer diameter (≤ 32 mm) and
thickness of the attachment tool must
correspond to the dimensional specific-
ations of your power tool.
• Mount the following attachment tools
on the corresponding adapter before
use:
• Cutting disc (small) (25), Sand-
paper (30): Mandrel (cutting and
grinding discs) (18)
• Grinding belt (28):Mandrel (abras-
ive belt) (26)
• Polishing disc (24, 29): Mandrel
(polishing disc) (19)
• The mounting key (27) serves as a
spanner for the clamping nut (9) and
as a screwdriver for the mandrel for
discs (18).
• Note the protrusion a indicated for
each attachment tool.
• Risk of damage! Never tighten the
clamping nut if no attachment tool is in-
serted in the collet.
50
rpm* ≤
25000
25000
25000
25000
−1
]; operate attachment tools with MIN only at minimum speed.
Use
Grinding work on stone,
wood, fine work on hard ma-
terials such as ceramics or al-
loyed steel
Machining metal, plastic and
wood
Requirements
• Battery removed.
Mounting a disc on the mandrel
1. Loosen the screw on the disc adapter
(18).
2. Guide the screw through the hole of
the desired disc (25/30).
3. Reattach the screw to the disc adapter
(18).
NOTICE! Breaking the disc. Tighten
the screw by hand only.
Mounting a grinding belt on the
mandrel
1. Slide the grinding belt (28) onto the
mandrel (26).
2. Pull a worn abrasive belt (28) back off
the mandrel (26).
Mounting a polishing disc on the
mandrel
1. Put the centring hole of the polishing
disc (24, 29) on the mandrel (19).
2. Tighten the polishing disc (24, 29) on
the mandrel (19).
Procedure (Fig. A)
1. Press and hold the spindle lock (5).
2. Loosen the clamping nut (9).
You can release the spindle lock (5)
Protrusion a
[mm] (Fig. A)
10
12–18
10
12–18