EUROM Heat-Duct-Pro HDP 3 Instructions De Service page 26

Control panel for HEAT-DUCT-PRO 9 and 15:
Location and Connection
 Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
 Mounting griff HDP 3 + 9
Mount the grip as shown in the illustration.
1 = screw M5x22
2 = spring washer Ø5
3 = washer Ø5 x 10
Mounting trolley HDP 15
Mount the trolley as
shown in the illustration
and description.
2x frame
12x screw M6x45
2x small wheels
2x plastic cover plate
4x washer
2x nut
- First mount the bottom
frame (see Figure 1)
- Then mount the weels
(see Figure 3)
- Then mount the upper
frame (see Figure 5)
The control panel for the
HEAT-DUCT-PRO 9 +
15 has two buttons:
 Left
 On
26
the freely
adjustable thermostat
knob
the right the
control knob with four
settings