Silk-n BRIGHT Mode D'emploi page 13

1. Plug the smaller end of the USB cable
EN
port
8
2. Plug the larger end of the USB cable into the USB port of the
USB wall adapter
You may also plug the USB cable to a compatible USB power
source (e.g. USB port of a computer) for charging.
3. Plug the USB wall adapter into a mains socket for charging.
During charging, the LED light
to blink.
4. The LED light will become solid white when it is fully charged.
Unplug the USB wall adapter from the mains socket and
disconnect the USB cable from the facial brush.
6 Operation
• Clean the facial brush before first use as described in
• Before cleansing an area of the face for the first time,
• The LED light
6.1 Using different areas of the facial brush
Area
Cleansing area
(thicker studs)
Cleansing area
(thinner studs)
Massaging area
(ridges)
4
6.2 Operation modes and speed settings
The facial brush is equipped with a vibrating and a pulsating mode.
• The vibrating mode uses uniform vibrations for deep, gentle
cleansing.
• The pulsating mode uses alternating strong and weak
vibrations for a massage-like soothing effect.
13
.
.
10
the chapter "Cleaning".
perform a skin sensitivity test on a spot. Start your
treatment only if there is no adverse reaction.
3
flashes once whenever a button is pressed.
Best for
Precise cleansing and removal of dead skin
cells and horny layers.
1
Gentle cleansing of large areas such as
cheeks.
2
Massaging the skin for improved blood
circulation and promoting the absorption of
skin care products.
9
will become red and start
3
is solid white during operation and
into the charging