Stiebel Eltron WDH 600 SBB Instructions D'installation page 5

INSTALLATION
Fitting the thermal insulation
f Connect the thermal insulation sections at the front by clip-
ping the hook closure strip into the last hook strip. If neces-
sary, the short black cover strips can be used to temporarily
hold the hook closure strips together.
f Position the thermal insulation sections around the cylinder
and connect the thermal insulation sections at the back by
clipping the hook closure strip into the first or second hook
strip.
f Adjust the thermal insulation sections to fit the appliance by
patting and pressing them down with the palm of the hand.
f Starting from the top, retighten the hook closure strip from
the top until it hooks into the final hook strip.
f Place the upper thermal insulation ring and thermal insu-
lation section on top. Use the slit to route the consumption
indicator over the thermal insulation to the front of the
appliance.
3
1 Cover
2 Protective anode
3 Signal anode consumption indicator
f Position the cover on the appliance, starting at the front, and
guide the consumption indicator of the anode through the
recess in the edge of the cover.
f Place the cover over the thermal insulation sections.
f Affix the label "Signal anode information" in a clearly visible
position on the thermal insulation.
f Fit the cover strips onto the hook closure strips. If required,
the cover strips can be trimmed to size.
f Fill the hollow spaces near the connections with the soft
foam inserts.
f Push the roses and caps into the apertures.
Note
Affix the additional type plate in a clearly visible position
on the thermal insulation.
www.stiebel-eltron.com
1
2
WDH SBB | 5