Stihl RM 650.0 T Manuel D'utilisation page 55

RM 650 V, RM 650 VE, RM 650 VS,
RM 655 V, RM 655 VS, RM 655 YS:
Setting the driving speed
Fast – Push driving
speed lever forward
Slow – Pull driving
speed lever back
7. Standard equipment
Item Designation
A
Basic unit
B
Lower part of grass catcher
box
C Upper part of grass catcher
box
D
Pin
E
Sleeve
F Bolt
G
Washer
H
Nut
I
Mulch insert – installed in
discharge chute (RM 650 T,
RM 650 V, RM 650 VE,
RM 650 VS, RM 655 V,
RM 655 VS, RM 655 YS)
J
Battery (RM 650 VE)
K
Charger (RM 650 VE)
– Instruction Manual
– Engine Instruction
Manual
0478 111 9953 B - EN
8. Preparing the machine for
operation
8.1 General
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
● Place the machine on level and firm
ground when performing all the
operations described.
8.2 Assembling the handlebar
● 1 Insert sleeve (E) in the bore
on handlebar (1).
2
● 2 Fit two washers (G) with the convex
Qty.
side facing inwards onto the sleeve.
1
● 3 Hold sleeve (E) and washers (G)
and insert together with handlebar (1)
1
into handlebar console (2) from below.
● 4 Fold handlebar (1) upwards until the
1
bores in the handlebar console and
2
sleeve (E) are aligned.
1
● 5 Place nut (H) in the handlebar
1
console recess and hold.
2
● 6 Insert bolt (F) from the outside
1
inwards through the bores in handlebar
console (2) and the sleeve. Tighten
bolt (F).
Tightening torque: 18 - 22 Nm
● Fold down the handlebar into the
1
transport position. (
1
1 Attaching cables:
1
Avoid damage to the machine!
Never kink cables or damage cable
1
covers.
● Insert all cables (3) into the guide on
handlebar console (4). To do this,
slightly bend the cables – without
kinking them – and insert into
guide (4) as shown.
RM 650 VS, RM 655 RS, RM 655 VS,
RM 655 YS:
Place the BBC cable (
guide (4) first.
5.).
● Insert all cables (3) into cable guide (5).
● Fold up the handlebar into the working
position. (
● RM 655 YS:
Adjust the self-propulsion cable.
( 14.11)
3
8.3 Attaching and detaching the
recoil starter rope
RM 650 VE: The engine does not
have a recoil starter rope.
Attaching:
● Detach the spark plug socket from the
engine.
● RM 650 T, RM 650 V, RM 655 V:
Press motorstop lever (1) to the
handlebar and hold.
● Slowly pull out recoil starter rope (2)
and attach it to rope guide (3).
● Slowly release recoil starter rope (2)
and motorstop lever (1).
● Connect the spark plug socket.
Detaching:
9.3)
● Detach the spark plug socket from the
engine.
● RM 650 T, RM 650 V, RM 655 V:
Press motorstop lever (1) to the
handlebar and hold.
= 7 mm) in
9.3)
4
53