Parkside PBH 1050 D4 Mode D'emploi page 31

˜ Switching on/off
Insert the mains plug
o
The LED lights up to indicate that the
[ 6 ]
product is ready for use.
Switching on
Press the on/off switch
o
Do not switch the power tool on unless you
o
plan to use it, to save energy.
Switching off
Release the on/off switch
o
At low temperatures, the power tool will only
o
reach its full hammer performance/strike
power after a certain time.
Continuous operation
Press the on/off switch
o
press the lock button
switch.
To cancel continuous operation, press the on/
o
off switch and release it.
[ 3 ]
˜ Selecting rotational speed
NOTE
The set speed is only reached in continuous
u
operation.
Rotate the speed selection wheel
o
the rotational speed from level 1 (low) to level
6 (high). The required speed depends on the
material to be processed.
˜ Troubleshooting
Problem Possible
cause
The product The motor is
does not defective.
work.
into a socket-outlet.
5 ] [
.
3 ] [
.
3 ] [
. At the same time,
3 ] [
to lock the on/off
4 ] [
to select
7 ] [
Solution
Have the
product
repaired by
a qualified
specialist.
Problem Possible
cause
The Excessive
performance pressure on
of the the product.
product is
poor.
The drill
chuck grease
is used up.
˜ Cleaning and maintenance
m WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments, cleaning and when not
in use.
˜ Cleaning
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces.
Never allow fluids to get into the product.
u
The product must always be kept clean, dry
u
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help
u
ensure safe use and prolong the life of the
product.
Clean the product with a dry cloth. Use a soft
o
brush for areas that are hard to reach.
In particular clean the air vents after every
o
use with a cloth and soft brush.
The air vents must always be clear.
Solution
Apply
appropriate
pressure to the
product.
Lightly grease
the SDS-Plus
tool holder
[ ]
with drill chuck
grease.
GB/IE 31