Parkside PBH 1050 D4 Mode D'emploi page 29

Injuries and damage to property due to
broken accessory tools or the sudden impact
of hidden objects during use.
Danger of injury and property damage
caused by flying objects.
˜ Before use
˜ Accessories
m WARNING!
Do not use accessories not recommended
u
by . This may result in electric
shock or fire.
To operate this product safely and correctly, the
following accessories, i.e. tools and accessory
tools, are necessary:
SDS-Plus insertion tool
o
Suitable personal protective equipment
o
Accessories and accessory tools are available
through your authorised dealer. When buying
always consider the technical requirements of this
product (see "Technical data"). If you are not
certain, ask a qualified specialist and get advice
from your trusted dealer.
˜ Operation
m WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments, cleaning and when not
in use.
WARNING!
m
Secure or fasten the workpiece during
u
drilling operations by using a clamp,
lockable pliers or a vice. Only perform
drilling works to a workpiece that is
securely fastened.
NOTE
Push the rotation direction switch
u
the middle position before carrying out any
work on the power tool (e.g. maintenance,
tool-changing, etc.) as well as during
carriage and storage of the power tool.
Unintentional activation of the on/off
switch can result in injury.
3 ] [
˜ Installing the auxiliary handle
NOTE
For safety reasons, only use this product
u
with the auxiliary handle
1. Loosen the strap on the auxiliary handle
by turning it anticlockwise.
2. Turn the auxiliary handle
angle depending on your working position.
3. Turn the auxiliary handle
tighten it.
˜ Installing the depth stop
1. Loosen the depth stop screw
2. Insert the depth stop
handle .
[ ]
3. Pull the depth stop
between the tip of drilling tools and the tip of
the depth stop corresponds with the required
drilling depth.
4. Tighten the depth stop screw
depth stop .
[ ]
˜ Selecting a tool
Application
Hammer drilling
Chiselling
into
[ 2 ]
attached.
[ ]
[
into a proper
[ ]
clockwise to
[ ]
.
[ 1 ]
into the auxiliary
[ ]
out until the distance
[ ]
to lock the
1 ] [
Tool
SDS-Plus insertion tool
GB/IE
]
29