Disposal; Troubleshooting - PrimAster PMAAS 40 Manuel D'utilisation

GB ENGLISH

DISPOSAL

If your device should become useless somewhe-
re in the future or you do not need it any longer,
do not dispose of the device together with your
domestic refuse, but dispose of it in an environ-
mentally friendly manner.
Please dispose of the device itself at an according collec-
ting/recycling point. By doing so, plastic and metal parts
can be separated and recycled. Information concerning
the disposal of materials and devices are available from
your local administration.
Batteries are not to be put into the rubbish. As a consu-
mer you are legally obliged to return used batteries and
accumulators. At the end of the duration of your appara-

TROUBLESHOOTING

Warning!
Always remove the rechargeable battery before inspection and adjustment work.
Check the rechargeable battery capacity. If the charge level is low, this can lead to more blockages. Continue working
with a fully charged rechargeable battery.
The following table lists error symptoms and describes how remedial action can be taken if your machine is not wor-
king properly. If this does not help to locate and eliminate the problem, contact your service workshop
Cause
Pole-mounted pruner is not
working
Pole-mounted pruner is
working erratically
Saw chain is dry
Chain/guide rail hot
Pole-mounted pruner does not
pluck, vibrate or saw properly
32
tus, the batteries or accumulators have to be taken from
the apparatus, disposing of them separately. You have the
possibility of delivering your old batteries and accumula-
tors to the local collecting points of your municipality or
to your dealer or to the distribution centers.
Dispose of the batteries when discharged. We recom-
mend applying an adhesive tape on the poles to protect
them against short circuit. Never open the battery.
Fault
The battery is empty
The battery is faulty
Loose internal contact
Ein-/Ausschalter defekt
No oil in tank
Vent in the oil tank cap blocked Clean the oil tank cap
Oil outflow channel blocked
No oil in tank
Vent in the oil tank cap blocked Clean the oil tank cap
Oil outflow channel blocked
The chain is blunt
Chain tension too loose
The chain is blunt
The chain is worn
Saw teeth point in the wrong
direction
Remedy
See "Charging the rechargeable
battery"
Have it replaced by our
specialist service department.
Visit a specialist workshop
Visit a specialist workshop
Top up oil
Clear the oil outflow channel
Top up oil
Clear the oil outflow channel
Resharpen or replace the chain
Adjust chain tension
Resharpen or replace the chain
Replace the chain
Refit saw chain with teeth in
correct direction