Installing The Leg Skirt - Hatco FSCD Série Manuel D'installation Et D'utilisation

INSTALLATION
11. Install the front sign holder.
a. Loosen, but do not remove the three hinge screws that
secure the fixed hinge to the base. Loosen until there is
enough room to slip the sign holder mounting flange
between the fixed hinge and the base.
b. align the screw cutouts on the sign holder mounting
flange with the three screws on the fixed hinge.
c. Slide the sign holder mounting flange between the fixed
hinge and the base. Slide in the sign holder until it stops.
d. Tighten the three hinge screws to secure the fixed hinge
and the front sign holder to the base.
Hinge
Screw
Front Sign
Holder
Installing Front Sign Holder (view from above)
12. Reinstall the curved front glass panel.
a. Lower the hinge bracket on the glass panel onto the
fixed hinge on the front edge of the base.
b. Carefully rotate the panel toward the unit until it rests
against the upper frame and the glass side panels.
c. Tighten the thumbscrews holding the curved glass
retaining clips on each side of the panel.

Installing the Leg Skirt

The leg skirt hides the 4" (102 mm) legs and drain (humidified
units) from view when looking from the customer side. Use the
following procedure to install the leg skirt.
1. Loosen the 4" (102 mm) legs until there is enough room
between the legs and the bottom of the unit for the leg skirt
to slide between.
2. From the front of the unit, pull out on each side of the leg
skirt to wrap it around the sides of the unit.
3. Slide the front leg cutouts on the leg skirt between the front
legs and the bottom of the unit.
4. Slide the rear leg cutouts on the leg skirt between the rear
legs and the bottom of the unit.
Fixed
5. Tighten the 4" (102 mm) legs to secure the leg skirt in
Hinge
position.
Screw
Cutout
Mounting
Flange
Rear Leg
Cutout
Leg Skirt
8
English
Front
Leg Cutout
Leg Skirt Installation
Form No. FSCDm-1016