Publicité
Les langues disponibles
Les langues disponibles
English
1
Left:
Bottom of cap is twisted –
inner mark (1) in line with
outer mark.
Right:
Bottom of cap in correct posi -
tion – inner mark is under the
grip. It is not in line with the
outer mark.
Place the cap on the opening and
N
rotate it counterclockwise until it
engages the filler neck.
Continue rotating the cap
N
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
Turn the cap clockwise and lock it in
N
position – see section on "Closing".
18
Checking Chain Lubrication
The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate without chain lubrication.
If the chain runs dry, the whole cutting
attachment will be irretrievably damaged
within a very short time. Always check
chain lubrication and the oil level in the
tank before starting work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
Adjusting the Telescoping
Shaft
WARNING
Always shut off the engine and fit the
chain guard
Loosen the screw.
N
Adjust shaft to the required length.
N
Tighten down the screw firmly.
N
HT 131
Publicité
