Publicité
Les langues disponibles
Les langues disponibles
English
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
Fit the chain – start at the bar nose.
N
12
5
1
4 3
Fit the guide bar over the screw (3)
N
and engage peg of tensioner slide in
the hole (4) – place the chain over
the sprocket (5) at the same time.
Turn the tensioning screw (1)
N
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
Refit the cover and screw on the nut
N
fingertight.
Go to chapter on "Tensioning the
N
Saw Chain"
Tensioning the Chain
1
Re-tensioning during cutting work:
Shut off the engine
N
Loosen nuts
N
Raise the guide bar at the nose
N
Use the screwdriver to turn the
N
screw (1) to the right until the saw
chain rests against the underside of
the guide bar
Raise the guide bar further and
N
tighten the nuts securely
Next step: Continue with "Checking
N
Chain Tension"
A new saw chain has to be re-tensioned
more often than one that has been in
use for some time.
Check chain tension frequently –
N
see chapter on "Operating
Instructions"
HT 131
Publicité
