TOOLCRAFT LDM 70 Mode D'emploi page 39

2. Now measure the two required segments. For the order, refer to the
following drawing or to the relevant flashing segment of the indicator
for indirect measurement.
3. After the second segment has been measured, the height will be
calculated automatically and shown on the display.
With three reference points (addition)
1. Press the button "Indirect Measurement" twice. The indicator for
indirect measurement with three reference points (addition) will be
shown in the top of the display.
2. Now measure the three required segments. For the order, refer
to the following drawing or to the relevant flashing segment of the
indicator for indirect measurement.
3. After the third segment has been measured, the height will be
calculated automatically and shown on the display.
39