Quick Programming; Selection Of The Language; Setting The Temperature - aqua Technopool3 Mode D'emploi

TECHNOPOOL3
Dosing systems for swimming pools

4.0 QUICK PROGRAMMING

4.1 S
ELECTION OF THE LANGUAGE OF THE SYSTEM
Select option Language from the installer menu.
To confirm and exit, press key Enter for 3 seconds.
4.2 S
ETTING THE TEMPERATURE
Select option Temperature from the installer menu.
To confirm and exit, press key Enter for 3 seconds.
ADSP7000570
Temperat. Mode
Indicates how the temperature is managed: manually, automatically (with probe
PT100) or OFF (deactivated).
Press keys ▼▲ to select the mode and Enter to confirm.
PT100 offset (only if the Temperat. Mode is PT100)
This parameter allows to adjust the temperature display. In fact, the offset value
can be added to or removed from the measured temperature, so to display the
desired value. This parameter is not considered for the calculation of the dosing
but only for the display.
Press keys ▼▲ to set the desired value and Enter to confirm.
Values that can be set are -5.0÷10.0.
Man. Temperat. (only if the Temperat. Mode is Manual)
It represents the coefficient for calculating the compensation of conductivity; it is
recommended to leave the default value.
Press keys ▼▲ to set the desired value and Enter to confirm.
Values that can be set are 0÷100° C.
rev. 1.6 09/01/2014
QUICK PROGRAMMING
ENGLISH
45/136