Solenoid Valve Output (Relay); Pump Switches; Hydraulic Connections - aqua Technopool3 Mode D'emploi

TECHNOPOOL3
Dosing systems for swimming pools
2.2.8 Alarm output – 24V OUT Clamp
It is an alarm repetition output that provides a voltage at 30VCC with a
maximum absorption of 500mA.
2.2.9 Solenoid valve output – RELAY Clamp
RELAY clamp provides a dry contact (not live) and it is used to control
the solenoid valve.
To have a voltage on the RELAY clamp equal to the power voltage, i.e.
230VAC, follow the diagram indicated on the side.

2.2.10 Pump switches

The system can be set with dose enable switches for each pump, which block the dosing of the associated pump.
Switches are connected to the circuit in the following way:




2.3 Hydraulic connections

ADSP7000570
P1 Pump
pH Pump
P2/Rx/Cl/HP Pump
rev. 1.6
on input pulse
on connector J16
on connector J15
09/01/2014
INSTALLATION
ENGLISH
39/136