Publicité
!
30
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED
OFF PRIOR TO ANY MAINTENANCE.
Located in your waste water (top) tank is a full tank switch, this stops your machine from
working once the waste water reaches its maximum limit. Sometimes the switch gets
clogged and blocked, clean to ensure correct operation (see page 24).
Remove white filter and rinse using clean water, and refit.
IMPORTANT:
Never use the machine without the recommended filter as it may cause damage to
the machine.
Remove debris basket filter and rinse using clean water, and refit.
IMPORTANT:
If the debris basket is allowed to become clogged, vacuum performance can deteriorate.
The clean-water tank filter is located to the rear of the battery compartment, and should
be checked at regular intervals. Lift white plug and remove white filter, rinse and refit.
Ensure tank has been emptied and care is taken when working in the vicinity of batteries.
NOTE: ANY SPILLS SHOULD BE WIPED-UP BEFORE TANK IS LOWERED.
After use, empty waste-water tank using emptying hose
and flush-out with clean water.
Next remove floor-tool vacuum hose and flush out
with clean water.
B
Next empty clean water tank, using emptying hose
and again flush out with clean water.
A
B
C
235670 09/13 (A12)
!
C
Before removing
separator, first pull-off
connected hoses.
Whilst pressing in the
separator toggles, remove
hood and rinse using clean
water.
The hood also has a
sealing-rubber which should
be examined at every
clean-down.
A
Publicité
