Publicité
Setting the operator pre-set buttons
Waste-water tank fill level warning light
Brush pressure / Load adjustment
NOTE: The run-time of the machine may decrease
if the load on the brushes is increased.
24
Settings can be stored using one of the three pre-set store buttons (S1/S2/S3).
Once settings are entered (chemical dose, brush speed and water-flow), press and
hold one of the three pre-set store buttons, a light will flash then remain constant;
your settings are now saved.
This facility can be re-set as often as you wish by simply following the steps above.
Cleaning Speed setting (CS). When this button is activated the speed is restricted to
3.5km/hr maximum even with the accelerator pedal fully depressed.
This is ideal for long cleaning periods.
Once this pre-set button is switched-off, the machine will operate at up to a maximum
speed of 7.0km/hr.
When the waste-water tank becomes full, a red warning light will illuminate on the
operator control panel (as illustrated) and the vacuum motor will stop automatically
after 5 seconds.
The waste-water tank requires emptying (see page 30).
The machine is equipped with a brush-pressure load-warning system.
If the brush load increases due to changing floor types, the pressure can be adjusted
manually by the operator using the adjuster knob found on the left hand side of the
control column.
Turn it anti-clockwise to decrease load on the brushes and clockwise to increase
load/pressure on the brushes. (see fig.33).
235670 09/13 (A12)
S1 S2 S3
CS
Fig.33
Publicité
