Télécharger Imprimer la page

Yamaha TT-R90 2000 Manuel D'atelier Du Proprietaire page 52

Publicité

STARTING AND OPERATION
CAUTION:
Prior to operating the machine, perform
steps listed in pre-operation check list.
WARNING
Never start your engine or let it run for any
length of time in a closed area. The exhaust
fumes are poisonous and can cause loss of
consciousness and death within a short
time. Always operate your machine in an
area with adequate ventilation.
STARTING A COLD ENGINE
WARNING
Before starting the engine, be sure to shift
the transmission into neutral.
1. Turn the fuel cock to "ON".
2. Operate the starter (choke) and com-
pletely close the throttle grip.
3. Slide the "ENGINE STOP" switch to the
"
".
4. Kick the kick starter with full strength to
start the engine.
5. After the engine starts, warm up for one
or two minutes. Make sure the stater
(choke) is returned to the original position
before riding.
STARTING A WARM ENGINE
To start a warm engine, refer to the "Starting a
cold engine" section. The starter (choke)
should not be used. The throttle should be
opened slightly.
CAUTION:
See "Engine break-in Section" prior to
operating engine for the first time.
STARTING AND OPERATION
WARMING UP
To get maximum engine life, always "warm-up"
the engine before starting off. Never acceler-
ate hard with a cold engine! To see whether or
not the engine is warm, see if it responds to
throttle normally with the stater (choke) turned
off.
WARNING
Before starting off, be sure to turn up or
remove the side stand.
Failure to retract the side stand completely
can result in a serious accident when you
try to turn a corner.
ENGINE BREAK-IN
Brake-in is important to better fit the moving
and sliding parts as well as the installed parts.
It is also important to accustom the rider to the
machine better.
Avoid full-throttle run on a new machine for the
first 5 hours.
After the trial run, check for loose parts, oil
leakage and other problems.
Make full inspection and adjustment especially
of slack cables and drive chain and loose
spokes.
CAUTION:
After the break-in period, check every fit-
ting and fastener for looseness.
If any loose is found, retighten it securely.
1 - 12
GEN
INFO

Publicité

loading

Ce manuel est également adapté pour:

Tt-r90n 2000