Publicité
SPARK ARRESTER CLEANING (For USA)
2
1
6. Install:
Tappet cover (intake side) 1
O-ring 2
7. Install:
Tappet cover (exhaust side)
O-ring
Spark plug
Timing plug
Crankshaft end cover
8. Install:
Air filter case
Air scoop (right)
SPARK ARRESTER CLEANING (For USA)
WARNING
Be sure the exhaust pipe and muffler are
cool before cleaning the spark arrester.
Do not start the engine when cleaning the
exhaust system.
1. Remove:
Bolt (tailpipe) 1
2. Remove:
Tailpipe 2
Pull the tailpipe out of the muffler.
3. Clean:
Spark arrester
Use a wire brush to remove any carbon
deposits from the spark arrester portion
of the tailpipe.
Tap the tailpipe lightly and remove the
carbon deposits from the outside por-
tion of the tailpipe.
4. Install:
Tailpipe
Insert the tailpipe into the muffler and
align the bolt hole.
Bolt (tailpipe)
3 - 10
INSP
ADJ
18 Nm (1.8 m · kg, 13 ft · lb)
New
18 Nm (1.8 m · kg, 13 ft · lb)
New
13 Nm (1.3 m · kg, 9.4 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
Publicité
