LiftMaster CAPXLV2 Manuel D'installation page 6

INTRODUCTION
Door of Control Board Overview
INTRODUCTION
The CAPXLV2 has a combination of access control inputs/outputs on the door of control board(s) that work in conjunction to control up
to 4 access points each, so CAPXLV2 can control up to 8 access points in total.
DO NOT use the Wiegand 12V power output port to power
anything except the Wiegand proximity readers.
INTRODUCTION
Wiegand 1
Monitored
Input 1
INTRODUCTION
Monitored
Input 2
Relay 1
Relay 2
INTRODUCTION
Wiegand
Output
INPUT/OUTPUT
Monitored Inputs
Relay
Wiegand Input
Wiegand Output
NOTE: Only the 26-bit Wiegand protocol and OSDP protocol are compatible in UL installations.
ACCOUNT SETUP
ACCOUNT SETUP
ACCOUNT SETUP
Wiegand 2
Monitored
Input 3
ACCOUNT SETUP
Monitored
Input 4
Relay 3
Relay 4
ACCOUNT SETUP
TYPE (CONFIGURABLE) USED FOR
REX External Free Exit Loop Detectors, REX Buttons, and Proximity Sensors
(Request to Exit)
Knox Box In the case of an emergency (medical or fire), the Fire Rescue Department
is able to gain entry.
Status Door sensors detecting when door is ajar.
Supervised Gate Operators detecting when failed to close.
Supervised Gate Operators detecting when failed to open.
Gate Operator, Door Strikes, Alarm Shunt, Maglocks, and Lights (for
control only - power to be provided by external supply)
Proximity Readers (Wiegand 12Vdc power is for readers only, do not use
to power other external devices).
Access grant activity for integration with other access systems
POWER NETWORK/MOUNTING
POWER NETWORK/MOUNTING
POWER NETWORK/MOUNTING
Monitored
Input 5
POWER NETWORK/MOUNTING
Monitored
Input 6
Relay 5
Relay 6
POWER NETWORK/MOUNTING
Wiegand
Output (for
internal use
only. Do not
connect.)
NOTE: Monitored inputs can operate in
any of the following configurations: Rex,
knox box, or status.
6
ACCESS CONTROL
ACCESS CONTROL
ACCESS CONTROL
Wiegand 3 Wiegand 4
ACCESS CONTROL
ACCESS CONTROL
Monitored
Input 7
Monitored
Input 8
Relay 7
Relay 8