Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION
1
Remove Knockouts
1.
Turn the key clockwise to unlock the CAPXLV2.
INTRODUCTION
2.
Open the door and lay the CAPXLV2 face down on
a table with the door hanging off the edge of the
table as shown.
3.
Identify which knockouts need to be removed
based on your application.
INTRODUCTION
4.
Use a center punch tool to remove the knockouts
from the outside of the box inward using an
appropriately sized punch and hammer.
NOTE: Be careful when removing the knockouts to
avoid damaging the CAPXLV2 components.
ACCOUNT SETUP
ACCOUNT SETUP
ACCOUNT SETUP
R
R
E = Electrical Wiring
P = Pedestal Mount
R = Recess Mount
S = Radio Antenna
W = Wi-Fi
POWER
NETWORK/MOUNTING
To prevent damage to the CAPXLV2 from moisture or water:
POWER
NETWORK/MOUNTING
• DO NOT install during rain. Internal components MUST be
kept free from of water and moisture.
• BEFORE opening the front cover of the CAPXLV2, remove
ANY accumulated water from the top of the CAPXLV2.
To prevent damage to ANY internal components:
• DO NOT attempt to remove the knockouts with a hammer.
POWER
Banging on the knockouts may result in shock to the circuit
NETWORK/MOUNTING
boards, which could cause permanent damage.
• Some internal wires may be close to the knockouts. Make
sure to move any wire away from knockouts.
R
W
W
S
P
P
E
P
P
Antenna
®
11
ACCESS CONTROL
ACCESS CONTROL
ACCESS CONTROL
R
R
Publicité
