Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION
Wiegand Card Reader
The CAPXLV2 is designed to fit multiple readers on the flexible
reader mount inside the chassis.
1. Disconnect power from the CAPXLV2.
2. Secure the Reader to the Mounting Plate with the supplied
screws.
3. Place the reader against the glass in the CAPXLV2.
4. Secure the Reader and Mounting Plate assembly into the
CAPXLV2 with two screws in the side wings.
5. Apply silicon around the cable hole.
6. The reader can be wired to any of the 4 Wiegand Inputs on the
door of control board(s). Insulate any unused wires from the
CAPXLV2 to prevent a short. (Refer to instructions provided
with your Reader for more information.)
7. Reconnect power to the CAPXLV2.
8. Refer to myQ
for programming.
®
ACCOUNT SETUP
POWER
NETWORK/MOUNTING
NOTE: To fit the mounting plate and the cavity, the reader
dimensions can not exceed 4" x 2".
21
ACCESS CONTROL
READER BRACKET
Publicité
