LiftMaster CAPXLV2 Manuel D'installation page 12

INTRODUCTION
2
Mount CAPXLV2
1. Attach the goose-neck gasket (provided) if mounting to a goose-neck.
INTRODUCTION
2. Mount the CAPXLV2 securely to a flat surface or pedestal with appropriate
hardware taking care to route wiring through appropriate knockouts.
Stainless steel hardware is recommended to mount the CAPXLV2. Use of
zinc plated or galvanized hardware is at risk for galvanic corrosion.
NOTES:
• Ensure the cover can fully open to allow access after the installation is complete.
INTRODUCTION
• Ensure that the back opening is properly sealed after the installation to avoid water or critters entering the intercom.
• ADA Compliance: When mounting the CAPXLV2 at a pedestrian entrance, to meet ADA compliance, mount the top of
the CAPXLV2 screen no higher than 54 inches from the ground.
• Do Not exceed a Max Bolts Length of 1.5" for Pedestal Mount Security Bolt.
• For surface and recess mounting, please use appropriate bolt length that secures CAPXLV2 to the surface completely.
The length will vary with the surface of the wall.
• When mounting the CAPXLV2, refer to the recommended screw quantity, type, length, and diameter in the table.
MOUNTING CONFIGURATION
Pedestal Mount
Recess/Surface Mount
* For Recess/Surface Mount applications, the recommended screw lengths are 13.54mm, 16.56mm, 19.72mm, and
22.76mm.
ACCOUNT SETUP
ACCOUNT SETUP POWER
ACCOUNT SETUP POWER
QUANTITY
4
4
Pedestal Mount
POWER NETWORK/MOUNTING
NETWORK/MOUNTING
NETWORK/MOUNTING
TYPE/LENGTH/DIAMETER
Metal/28.62mm/6.11mm
Metal/Length*/4.12mm
12
ACCESS CONTROL
DO
Make sure any internal wiring is inside the
chassis before you close the front panel
ACCESS CONTROL
of CAPXLV2 to prevent any moisture from
entering the chassis.
ACCESS CONTROL
Recess Mount
Surface Mount