Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION
1
Connect Internet
The CAPXLV2 can connect to the Internet with a wired Ethernet connection or with Wi-Fi
the Admin Mode before you connect to the Internet. If you are not in Admin Mode, press the 3 dots in the upper right corner
INTRODUCTION
of the CAPXLV2 display and enter the Admin Code, enter the password (default is 888888), press the Network tab on the
CAPXLV2 display, and press the "NetworkSettings" and then "Change Network Settings" button. Follow the instructions
according to your application.
OPTION 1
Wired Connection
The Local Area Network (LAN) port is a 10/100 Ethernet interface with an RJ45 jack for connecting the CAPXLV2 to a hub, switch, or router
in order for it to gain connectivity to the Internet. Use a straight, (i.e., non-crossover) Cat5e, or Cat6 cable to connect to a local hub, switch or
router. This type of cable is referred to as an Ethernet cable in this manual.
1. Plug the input Ethernet cable into the main board.
2. Connect an Ethernet cable from the hub, switch, or router to the LAN port on the main board. When connected properly, the green and
amber LED on the Ethernet port of the main board will light/flicker (the main board is located on the back of the CAPXLV2 display). If the
green LED is not lit, check the connections on the CAPXLV2 and the Ethernet hub.
3. On the display, select Wired Network if dynamic configuration (DHCP) is desired or select Manual Setup for a static IP address.
OPTION 2
Connect through Wi-Fi
1. On the display select Wi-Fi
2. Select the network the CAPXLV2 will use.
3. Enter the password for the network.
4. Select Login.
Additional compatibility considerations:
• When checking signal strength in CAPXLV2 admin mode, at least two bars are recommended.
• Use accessory WFBTEXT (WiFi
up or to a location resulting in two or more bars.
• If using a Wi-Fi
signal strength tool or app, a continuous Wi-Fi
®
to zero are stronger strength) at the CAPXLV2 must be guaranteed to ensure an acceptable connection to the local network.
• Hidden network SSID's are not supported. The network must be selectable from the CAPXLV2 display.
• Wi-Fi
networks requiring secondary authentication are not supported (E.g. Hotels and airport Wi-Fi
®
2
Validate Setup
On the display, select each tab in Admin Mode to validate setup (network,
inputs, outputs, etc.). Once you have validated the setup, exit Admin Mode.
ACCOUNT SETUP
ACCOUNT SETUP
(Wireless)
®
Network.
®
External Antenna Kit) and WFAEXT (15' WiFi
®
POWER
NETWORK/MOUNTING
POWER
NETWORK/MOUNTING
Extension Kit) to move the CAPXLV2 antenna higher
®
signal strength connection of at least -65 DBM (numbers closer
®
16
ACCESS CONTROL
(wireless). Make sure you are in
®
ACCESS CONTROL
).
®
Publicité
