Publicité
Les langues disponibles
Les langues disponibles
V1,1
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace
the missing part before operating. Failure to do so could result in
a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for
damage. Make sure that all items in the contents are included.
Contents:
•
Stationary ring
•
Safety belt
•
1/8 in. Hexagonal spanner
•
1/2 in. chuck
•
Arbor assembly: 15/64 in. hexagonal spanner included
•
Drift
•
Arbor shank
•
Safety glasses
•
Spare brush
OPERATION
Numbers or codes references in parenthesis (#1) refer to the included
Parts List.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
Before operation, accomplish the following:
1.
Perform a complete check of the tool's electrical and operational
components to confirm there is no damage or need of repair.
2.
Ensure that the coolant bottle contains sufficient cutting oil to
complete the required operation. Refill as needed.
2.1 If operating in an inverted position, the gravity-fed coolant will not
work. Cutting paste or another form of lubricant should be used.
3.
Depress the pilot to ensure cutting fluid is being properly metered.
4.
Clear any debris or clutter near or in the tool, paying special
attention to the swarf.
Visit www.princessauto.com for more information
Magnetic Drilling and Tapping Press
9027525
9
Publicité
