PRO-POINT 9027525 Mode D'emploi page 18

9027525
CLEANING
1. Always ensure hands are well protected when handling cutters and
swarfs. Use a tool brush when necessary for cleaning.
2. Ensure work area is free from swarf, dirt or debris with special
attention to the magnet base.
MAINTENANCE SCHEDULE
DESCRPTION
Visual check of machine for
damage
Operation of machine
Check brush wear
Check magnetic base
Check alignment of tool
Check grease
Check armature
LUBRICATION
Inspect and lubricate the tool when required. Only use light oil to
lubricate the tool. Other lubricants may not be suitable and could
damage the tool or cause a malfunction during use.
When not in use for an extended period, apply a thin coat of lubricant to
the steel parts to avoid rust. Remove the lubricant before using the tool
again.
NOTICE! NEVER use a penetrating oil to lubricate the tool.
Penetrating oil may act as a solvent that will break down the
grease and cause the tool to seize up.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
18
Magnetic Drilling and Tapping Press
EVERY OPERATION WEEKLY
X
X
X
For technical questions call 1-800-665-8685
V1,1
MONTHLY
X
X
X
X