PRO-POINT 9027525 Mode D'emploi page 15

V1,1
15. Make any necessary further adjustment to the bracket and ensure
correct alignment of the
spindle and finally tighten the
screws using a spanner.
16. Tighten the arbor bearing
bracket.
WIRING
Observe the following (Fig. 7)
outline and specifications for wiring
with the control board (Fig. 7-1)
and display board (Fig. 7-2) to the
magnet sensor (Fig. 7-3).
# FUNCTION
1 Mains live input
2 Speed controller module lead wire
3 Speed controller module lead wire
4 Mains neutral input
5 Magnet positive output
6 Magnet negative output
7 Field coil lead wire
8 Field coil lead wire
9 Carbon brush lead wire
10 Carbon brush lead wire
# FUNCTION
A Motor reverse switch 0V
B Motor reverse switch +5V
C Motor forward switch 0V
D Motor forward switch +5V
E Magnet switch 0V
F Magnet switch +5V
G Magnet ON LED +5V
H Magnet ON LED +5V
Visit www.princessauto.com for more information
Magnetic Drilling and Tapping Press
WIRE COLOUR
Black
White
Red
White
Blue
Black
Blue
Green
Black
Brown
WIRE COLOUR
White
White
White
White
White
White
White + green
White + red
9027525
Fig. 7
15