PRO-POINT 9027525 Mode D'emploi page 3

V1,1
CAUTION! This notice indicates a potentially hazardous situation that
may result in minor or moderate injury if proper practices are
not taken.
NOTICE! This notice indicates that a specific hazard or unsafe
practice will result in equipment or property damage, but
not personal injury.
INTRODUCTION
This magnetic drilling and tapping press features a 2 HP motor and 2-
gear variable speeds with speed ratings of 100 to 265 RPM and 200 to
500 RPM. Use with annular cutters, twist drill bits and Weldon shank
drill and taps to drill holes and threads in a variety of material.
INTENDED USE
The intended use of this tool is to drill holes in ferrous metals. The
magnet is intended to hold the drill in place whilst the drill is functioning.
It is designed for use in fabrication, construction, railways,
petrochemical, and any other applications when drilling ferrous metals.
Any deviation from its intended use will not be covered by warranty.
GENERAL SAFETY RULES
WARNING! When using electric tools, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock and personal injury, including the following. Please read
these instructions before attempting to operate the machine.
Keep this manual for safety warnings, precautions, operating or
inspection and maintenance instructions.
1. Remove the power supply before carrying out any adjustment,
servicing or maintenance.
2. Keep work area clear—cluttered areas and benches invite injuries.
3. Consider the work area environment:
3.1 Do not expose tool to rain.
3.2 Do not use tool in damp or wet locations.
3.3 Keep work area well lit (500 Lux recommended).
3.4 Do not use tool in the presence of flammable liquids or gases.
3.5 Ensure there is adequate space to gain access to the tool's
plug, mains, and motor on/off switches.
Visit www.princessauto.com for more information
Magnetic Drilling and Tapping Press 9027525
3