PRO-POINT 9027525 Mode D'emploi page 13

V1,1
3. Position the machine on the centerline of
the pipe, ensuring the magnet is in line
with the longitudinal axis of the pipe.
4. Switch the magnet and move the sliding
plates down to the outside diameter of
the pipe.
5. Tighten the screws on both sides on
both sides by hand.
6. Check once again that the full length of
the moving plates is touching the pipe at the front and the back.
7. Fasten the plates securely.
8. Feed the safety strap through the lugs at the front of the housing
around the pipe and pull tight.
9. When cutting the hole, do not use excessive pressure.
FITTING THE CHUCK
This tool comes supplied with an arbor shank (RDC4087) and 1/2 in.
chuck (RDC4084).
1. Insert the arbor shank into the arbor spindle (RDC4009).
2. Ensure a tight fit.
3. Insert the 1/2 in. chuck into the arbor shank.
4. Ensure a tight fit.
To replace the chuck, simply reverse the above sequence, utilizing the
drift (RDC4086).
MOUNTING CUTTERS
This tool accepts cutters with 3/4 in. diameter Weldon shanks. To
mount the cutters, accomplish the following:
1. With the tool in the upright position, ensure the arbor assembly
(CA120) is fully inserted into the arbor spindle (RDC4009).
2. Take appropriate pilot and place through the hole in the shank
(RDC4087).
3. Insert the shank of cutter into bore of arbor assembly, ensuring
alignment of the two drive flats with socket screws.
4. Tighten both screws using hexagon key.
Visit www.princessauto.com for more information
Magnetic Drilling and Tapping Press 9027525
Fig. 6
13