Publicité
Les langues disponibles
Les langues disponibles
V1,1
13. Do not abuse the cord; never pull the cord to disconnect it from the
socket. Keep the cord away from heat, oil and sharp edges.
14. Secure work where possible, use clamps or a vice to hold the
work. It is safer than using your hand.
15. Do not overreach! Keep proper footing and balance at all times.
16. Maintain tools with care.
16.1 Keep cutting tools sharp and clean for better and safer
performance.
16.2 Regularly check the machine for any wear or damage.
16.3 Ensure the machine is clean and free from debris prior to
use.
16.4 Remove the mains prior to any maintenance.
16.5 Follow instructions for lubricating and changing accessories.
16.6 Inspect the tool cords periodically and if damaged have it
repaired by an authorized Unibor service facility.
16.7 Inspect extension cords periodically and replace if
damaged.
16.8 Keep handles dry, clean and free from oil and grease.
17. Disconnect tools from the power supply when not in use, before
servicing or when changing accessories such as cutters.
18. Form the habit of checking to see that keys and adjusting
wrenches are removed from the tool before turning it on.
19. Avoid unintentional starting. Ensure the magnet is off before
plugging the machine in.
20. Use extension leads only intended for outdoor use when the tool is
used indoors.
21. The vibration emissions during actual use can differ from the
declared total value depending on the ways in which the tool is
being used.
22. Watch what you are doing, use common sense and do not operate
the tool when you are tired. Do not operate the machine when
under the influence of alcohol or any illegal substances.
Visit www.princessauto.com for more information
Magnetic Drilling and Tapping Press
9027525
5
Publicité
