Publicité
Les langues disponibles
Les langues disponibles
9027525
7.
Excessive
1.
drilling
pressure
required
2.
3.
4.
Excessive
1.
cutter
breakage
2.
3.
4.
5.
6.
7.
22
Magnetic Drilling and Tapping Press
Loose bolts on motor
bushing support
bracket; main casting or
loose gib adjusting
screws
Incorrectly re-
sharpened, worn or
chipped cutter
Coming down on swarf
lying on surface of
workpiece
Gib strips out of
adjustment or lack of
lubrication
Swarf accumulated
(packed) inside cutter
Steel swarf or dirt under
cutter
Incorrectly re-sharpened
or worn cutter
Cutter skipping
Slide needs adjustment
Cutter not attached
tightly to arbor
Insufficient use of
cutting oil; unsuitable
type of oil
Incorrect speed
1.
Re-sharpen or replace
2.
Take care not to start a
cut on swarf
3.
Adjust set screws and
lubricate
4.
Clear cutter
1.
Remove cutter and clean
thoroughly
2.
Always have instructions
and new cutter on hand to
refer to for correct tooth
geometry
3.
See Care & Maintenance
section
4.
Tighten grub screws
supporting the slide
5.
Adjust set screws and
lubricate
6.
Inject light oil into the
coolant inducing ring
check that oil is being
metered into the cutter
when pilot is depressed. If
not, check the pilot groove
and arbor internally for dirt
or apply oil externally
7.
Ensure correct gear is
used for the cutter
For technical questions call 1-800-665-8685
V1,1
Publicité
