Publicité
Les langues disponibles
Les langues disponibles
V1,1
CARE & MAINTENANCE
WARNING! Always disconnect the tool from its power sources
before performing any inspection or maintenance.
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical replacement
parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool clean, dry and free from oil/grease at all times.
6.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
7.
Keep cutting edges sharp and clean.
8.
Machine brushes should be checked once a week to make sure
there is no abnormal wear present.
8.1. If worn more than 2/3 of original length, it should be changed.
9.
Before every operation, the magnetic base should be checked to
ensure it is flat and that there is no damage present. An uneven
magnet base may cause failure of operation and potential injury.
10. Check the gearbox grease once a month to ensure all moving
components are covered to prevent wear. The grease should be
changed at least once a year.
11. Check the armature of the machine at least once a month to
ensure there are no signs of damage to the body or the
commutator.
11.1
Some signs of wear are to be expected over time. If any
abnormal damage is noted, the parts should be replaced.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
Visit www.princessauto.com for more information
Magnetic Drilling and Tapping Press
9027525
17
Publicité
