GYS CAPATEK 66 FV Mode D'emploi page 26

Original instructions
2) Fitting the stud holder (Fig 15).
1) The head of the stud should protrude by about a millimetre.
This space limits the quantity of molten material projected onto the
stud holder.
2) Screw for adjusting the position of the stud. (Fig 15)
3) Unscrew the ring.
4) Insert the stud holder.
5) Tighten the ring securely (Fig 12.9).
3) Fitting the tripod ring with quarter-turn lock
Place the tripod in this position, then make a quarter
1) Force adjustment (Fig 12.10)
See (Fig 14) for the level of force required, according to
the material and size of the stud.
2) Retraction adjustment (Fig 12.4)
See (Fig 15) for the amount of retraction required, de-
pending on the material and size of the stud.
3) Voltage settings (See Synergy settings) Voltage is ad-
justable from 50V to 200V. Use the arrow keys.
Note: if necessary, press the cancel button to exit the
menu.
4) Lock settings (Optional) See Fig 20 and 21.
5) Position the earth clamps.
Double earth clamps are supplied to avoid the eff ects of magnetic blow-out, it is advisable to position them equidistantly
either side of the stud being welded.
26
turn to the right.
CAPATEK 66 FV
+
7
1
Tripod in correct position.
+
-
1
EN
2
-