GYS CAPATEK 66 FV Mode D'emploi page 18

Original instructions
1 Tripod ring with quarter-turn locking mechanism
2 Tripod rod with tightening fl ats
Retaining screw for retraction height adjustment cover (not present on contact
3
gun version)
4 Slider for adjusting retraction height from 1 to 5 mm
5 Cover for height adjustment knob (not present on contact gun version)
6 LED light
7 Screw to retain the force adjustment knob cover
8 Force adjustment knob cover
9 Stud holder
10 Force adjustment slider
11 Welding trigger
12 Gun control cable connector
13 Positive dinse
IV. ACCESSORIES
• Tripod ring with quarter-turn locking mechanism (Fig 12.1)
Place the tripod in this position, then
make a quarter turn to the right
By default, the tripod pins are positioned in inserts 1, 2 and 3.
In order to perform welds in difficult positions or on thin sheet material, the pins can be positioned differently if required.
Note: the pins do not act as earth contacts
• Stud holder
A stud holder box (080935) is available as an optional accessory:
M3 (081215)
M4 (049000)
M5 (048157)
M6 (048164)
M8 (064058)
18
CAPATEK 66 FV
Tripod in correct position
EN