VALBERG 14S40 B XAD929C Consignes D'utilisation page 28

B
Filling the rinse aid dispenser
1. Remove the rinse aid compartment cover by lifting the tab.
2. Pour the rinse aid into the compartment, taking care not to overfill it.
3. Then close the compartment by lowering the lid.
Adjusting the rinse aid dispenser
To achieve optimum drying performance with the least amount of rinse aid, the dishwasher
is designed to adjust consumption according to the user. Please follow the steps below.
1. Open the door and turn on the appliance.
2. Within 60 seconds after completing step 1, press and hold the "Programmes" button for
more than 5 seconds, then press the "Delay Start" button to enter the settings mode;
the rinse aid indicator will flash at a frequency of 1 Hz.
3. Press the "Programmes" button to select the right setting as usual. The settings display
order is as follows: D1 -> D2 -> D3 -> D4 -> D5 -> D1. The higher the number, the more
rinse agent the dishwasher will use.
4. Confirm and exit the setting by pressing the power button or not performing any other
operation for 5 seconds.
Using the appliance
26 EN