VALBERG 14S40 B XAD929C Consignes D'utilisation page 16

B
POSITIONING OF THE APPLIANCE
• Place the dishwasher in the desired location. The back of the appliance should rest
against the wall behind, and the sides against adjacent cabinets or walls. This dishwasher
is fitted with water supply and drain hoses which can be positioned on the left or right-
hand side for ease of installation; the hose should not be submerged in water to avoid
backflow.
Levelling the appliance
• Once the appliance has been positioned in the required location, the height of the
dishwasher can be changed by turning the adjustment feet. The appliance must never
be inclined by more than 2°.
PLEASE NOTE
This section applies to stand-alone dishwashers only.
STAND-ALONE INSTALLATION
Installation between existing cabinets
• Once the appliance has been positioned in the required location, the height of the
dishwasher can be changed by turning the adjustment feet. The appliance must never
be inclined by more than 2°.
• The height of this dishwasher (845 mm) is designed to allow it to be installed between
existing cabinets of the same height in modern fitted kitchens. The feet can be adjusted
to the correct height.
• The laminated top surface of the appliance does not require any special care, as it is
resistant to heat, scratches and stains.
Using the appliance
14 EN