VALBERG 14S40 B XAD929C Consignes D'utilisation page 14

B
WATER INLET AND OUTLET
Cold water connection
• Connect the cold water supply hose to a 1.9 cm threaded fitting and ensure that it is
tight.
• If the water supply pipes are new or have not been used for a long time, let the water run
to check it is clear. This is required to avoid the risk of the water supply being blocked,
which could damage the appliance.
CAUTION
A hose connected to a spray tap can burst if it is installed
on the same water pipe as the dishwasher. If your sink is
equipped with one, it is recommended disconnecting the
pipe and blocking the hole.
How do I disconnect the safety inlet hose?
1. Close the water supply.
2. Unscrew the safety inlet hose from the tap.
Using the appliance
12 EN