emerio DF-120485 Mode D'emploi page 7

4. Never use the deep fryer without oil or fat because this could damage the unit.
5. Never move the deep fryer during use. The oil becomes very hot and you can get burned. Wait to move the
deep fryer until the oil has cooled off.
6. This deep fryer is protected with a thermal safety device, which switches the machine off automatically if it
overheats.
7. Never immerse the unit in water.
8. Never leave the deep fryer unattended while in use. Always ensure the safety of children if they are near
the deep fryer.
9. If the deep fryer and/or cord are damaged, they must be repaired by a professional service department.
10. Do not try to repair the unit by yourself, neither to replace a damaged cord. This requires special tools.
11. Be sure not to damage the heating element. (Do not bend or dent.)
12. The electrical component is equipped with a safety cut-off, which ensures that the heating element can
only function when the element is correctly placed on the fryer.
SAFETY
Safety thermal cut-out
In the event of overheating, the thermal cut-out will switch off the deep fat fryer. This can happen if the deep
fat fryer is not filled with sufficient oil or solid frying fat is melted in the deep fat fryer. In the case of solid fat,
the heating element is unable to radiate the produced heat quickly enough. If the safety thermal cut-out
switches off the deep fat fryer, proceed as follows:

Allow the oil or fat to cool down.

Carefully push in the reset switch at the rear of the control element with a small screwdriver.
The deep fat fryer is now ready to use again.
Safety switch
The safety switch in the control element ensures that the heating element can only be switched on when the
control element locks in position.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50Hz
Power: 3300W
TROUBLESHOOTING
Device is not working
Troubleshooting:

Check the mains connection.

Check the position of the thermostat.
Troubleshooting:
Check that the control element is correctly in place.
Other possible causes:
The device is fitted with a RESET button.
This prevents the device being switched on accidentally.
Overheating Protection

If you should accidentally switch on your deep fat fryer when there is no oil or fat in it the overheating
protection is automatically turned on. The appliance is no longer ready to be used. Unplug the deep fryer.
- 6 -